A: The default IP address is192.168.1.168, which can be modified in the web settings as needed.

A: K10 supports SDI and CVBS video input formats, and you can switch between video sources in the web settings.

A: The output resolution adapts automatically according to the video source, supporting up to 1080p@60fps (H.264) or 4M@30fps (H.265).

A: Yes, in specific firmware versions, you can manually enable or disable it via the "Real-time Feedback On/Off" button in the upper computer software.

A: Yes, the autofocus function is enabled by default when the host computer starts. It can be disabled by clicking the "Autofocus On/Off" button.

A: RS422/485, 9600 bps.

A: Please ensure the wiring follows the communication interface definitions in the user manual and check for loose connections on the transmit and receive ends.

A: Before setting preset positions, ensure that code values of zoom- to zoom+ on the host computer increase progressively and the corresponding image is from wide field of view(WFOV) to narrow field of view(NFOV). Similarly, the code values of "focus-" to "focus+" should also increase. Once confirmed, adjust the image based on motor feedback values, then proceed with the preset configuration.

A: C1 and C2 are motor offset parameters for autofocus in the forward and reverse directions. You can ensure the accuracy of autofocus during calibration via adjusting C1 and C2 parameters.

A: On the Parfocal Setting interface, perform uniform focal length segmentation calibration to ensure each focal segment achieves the clearest imaging at the same temperature.